The Process Atrato® is based on our standard, wide ranging, Atrato® ultrasonic flow meter but packaged to address the more challenging industrial process and control environment. The body is 316 stainless steel, rated at 20 bar and the electronics are built-in and sealed to IP65. The only other wetted materials are PEEK and the customer’s choice of elastomers. The Process Atrato® is calibrated with a pre-set ‘K’ factor so all meters of the same flow range are fully interchangeable simplifying assembly and set-up procedures for OEM manufacturers. There are two adaptable frequency outputs, one PNP and NPN. Two multicolour LEDs indicate signal strength, power malfunctions and pulse outputs. Electrical connections are through a standard M12, four pin, sensor connector. Four flow ranges are available from 2 ml/min to 15 litres per minute, accuracy is ±1% over the whole flow range.
Download the Process Atrato® Datasheet
Refer to the full technical data below or call our technical team to discuss your specific application.
If you would like some help selecting a Flowmeter, our experienced team are always happy to help.
| Flow Range L/Min | ‘K’ Factor Pulses/Litre |
|---|---|
| 0.002-0.5 | 100000 |
| 0.01-1.5 | 20000 |
| 0.03-5.0 | 10000 |
| 0.10-15 | 2000 |
Product Data Sheet – Specification & Order Codes
Linearity and Repeatability for Process & Standard Atrato
Prior to installing the flow meter, read the Instruction Manual and refer to the following Installation Checklist to prevent avoidable failures due to mis-wiring etc.
For technical issues, refer to our Troubleshooting section or email technical@flowmeters.co.uk
Join our mailing list to receive fLowdown updates from Titan Enterprises.
Titan Enterprises Ltd
Unit 2, 5A Cold Harbour Business Park,
Sherborne,
Dorset, DT9 4JW
